Sony STR-DE805G Speaker System Hookups, Getting Started, Overview, CONTROL A1 Hookups, CD player

Getting Started

Hookups

The arrow •indicates signal flow.

CD player

Receiver	CD player
	OUTPUT
L	LINE
	L
R
IN	R
CD

Tape deck

Receiver	Tape deck
	OUTPUT	INPUT
L	LINE	LINE
		L
R
REC OUT IN		R
TAPE

DAT/MD

ReceiverDAT/MD

OUTPUT INPUT

L

LINE LINE

L

R

REC OUT IN R

DAT/MD

Turntable

Receiver Turntable

Speaker System Hookups

Overview

This section describes how to connect your speakers to the receiver. Although front (left and right) speakers are required, center and rear speakers are optional. Adding center and rear speakers will enhance the surround effects. Connecting an active woofer will increase bass response.

For specific locations of the terminals, see the illustration below.

FRONT SPEAKERS	IMPEDANCE
	SELECTOR

WOOFER REAR CENTER

SPEAKERS SPEAKER

For optimum surround sound effect, place your speakers as shown below.

OUTPUT

L LINE

L

R

IN R

PHONO

•If your turntable has an earth lead

To prevent hum, connect the earth lead to the y SIGNAL GND terminal on the receiver.

45°

Rear speaker

60 - 90 cm

Front speaker

CONTROL A1 Hookups

•If you have a CONTROL A1 compatible Sony CD player or tape deck

Use a CONTROL A1 cord (not supplied) to connect the CTRL A1 jack on the CD player or tape deck to the S-LINK CTRL A1 jack on the receiver. Refer the separate manual “CONTROL-A1 Control System” and the Operating Instructions supplied with your CD player or tape deck for details.

•If you have a Sony CD changer with a COMMAND MODE selector

If the CD changer’s COMMAND MODE selector can be switched between CD 1, CD 2, and CD 3, be sure to set the command mode to “CD 1” and connect the changer to the CD terminals on the receiver.

However, if you have a Sony CD changer with VIDEO OUT terminals, set the command mode to “CD 2” or “CD 3” and connect the changer to a set of the receiver’s video component terminals (VIDEO 1, VIDEO 2, or LD).

What cords will I need?

Speaker cord (not supplied) (1 for each speaker)

(+)	(+)
(–)	(–)

Twist the stripped ends of the cord about 15 mm. Be sure to match the speaker cord to the appropriate terminal on the components: + to + and – to –. If the cords are reversed, the sound will be distorted and will lack bass.

Hookups

Front speakers

Front speaker	Receiver		Front speaker
(R)			(L)
	FRONT SPEAKERS
	R	L
}]			} ]

(continued) 11EN