Sony STR-DE805G 23EN, Preparing and Using the Remote, If you make a mistake, To Erase IR codes

Preparing and Using the Remote

To switch between upper and lower case letters

Click CAPS.

If you make a mistake

Click ?or /to move the cursor to the character to be changed, then click the correct character (or click the space bar to erase the character).

5After entering the name, click RETURN to go back to the USER IR CODE SETTING menu.

Repeat steps 3 through 5 until you enter the names of all the IR codes you want to program.

6Click the name of the first IR code.

USER IR CODE SETTING
LIGHT 1	A	B C	D
LIGHT 2
LIGHT 3
LIGHT 4
RETURN			EXIT

Before going to step 7, cover the IR sensor on the respective equipment to prevent accidental operation during the programing procedure.

7Click on START.

When “PUSH YOUR COMMANDER” appears on the TV screen, press the button you want to program.

USER IR CODE SETTING
LIGHT 1		A	B	C	D
LIGHT 2
LIGHT 3		INDEX
LIGHT 4		START
PUSH	YOUR	COMMANDER
		CODE CLEAR
RETURN					EXIT

When programing the IR code, point the remote at the IR sensor on the receiver from a distance no greater than 10 cm and hold down the button on the remote for about 5 seconds until the instruction “RELEASE YOUR COMMANDER” appears and the IR code setting indicator turns off.

IR sensor

Keep the remote pointed horizontally at the IR sensor until the code is programed.

If you tilt or move the remote during the programing procedure, the IR code may not be programed correctly.

Repeat this procedure for the remaining buttons

After you’ve programed all the IR codes, the IR CODE SETTING menu reappears.

To reprogram a specific IR code.

Click the button where the IR code was programed, then click START.

To Erase IR codes

Click CODE CLEAR.

• To erase one specific IR code

1Click SINGLE IR CODE CLEAR

2Click the button you want to clear.

“Are you sure?” appears for confirmation.

3Click YES to erase the code.

“CODE CLEAR!” appears in the display. To stop before erasing a code, click NO.

To erase another code repeat steps 2 and 3.

•To erase all the user IR codes.

1Click USER IR CODE CLEAR.

“Are you sure?” appears for confirmation.

2Click YES to erase the codes.

“CODE CLEAR!” appears in the display. To stop before erasing the codes, click NO.

•To all the IR codes.

1Click ALL IR CODE CLEAR.

“Are you sure?” appears for confirmation.

2Click YES to erase the codes.

“CODE CLEAR!” appears in the display.

To stop before erasing all the codes, click NO.

Notes

•Even if the receiver’s power cord has been disconnected from the AC power outlet, programed IR codes will stay in the memory for approximately two weeks. If they disappear, “ALL CLEAR” will appear on the TV screen when you turn on the unit again.

•The power switch on some air conditioners use two independent IR codes, even when there is only one switch. If you cannot turn the air conditioner off with the IR code programed for the on/off switch, repeat the procedure and program the on and off IR codes separately.

•The operation of some air conditioner remote commanders require two–way signal exchange with the air conditioner itself. Though it is possible to program the IR codes of such remote commanders in the unit, their use may not result in normal air conditioner operation.

•The unit may not be able to register IR codes with special waveforms produced on some remote commanders.

23EN