Selecting the mode of the
remote
Set the remote mode using the USE MODE button and the remote mode buttons.
Selecting the command mode
You can switch the command mode (AV1 or AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
Press 1 (AV1) (or 2 (AV2)) while pressing down USE MODE.
The indicator lights once (twice for AV2) , then the command mode switches.
Setting to the 2nd room mode.
You can use the remote to select the function for the 2nd room (2nd room mode). You can use the function buttons only for the 2nd room.
Press 2ND while pressing down USE MODE
The indicator lights for a while, then the mode switches to the 2nd room mode.
Tips
•If you press a function button while pressing down SOURCE, you can select the function for the 2nd room even though the mode is not set to the 2nd room mode.
•If you press SOURCE only, you can output the source signal of the current function of the receiver to the amplifier in the 2nd room.
To check the mode of the remote
Press USE MODE. You can check the remote by the indicator.
Mode | Indicator lights |
AV1 | once |
|
|
AV2 | twice |
|
|
2ND | once (for a while) |
|
|
To reset the remote to factory settings
Press =/1, AV =/1, and MASTER VOL – at the same time.
The indicator lights 3 times, then goes off.
Programming the remote
You can program the remote to control non- Sony components by changing the code. Once the control signals have been memorized, you can use those components as part of your system.
Furthermore, you can also program the remote for Sony components that the remote is unable to control. Note that the remote can only control components that accept infrared wireless control signals.
1 Press AV ?/1 while pressing down USE MODE.
The indicator lights.
2 Press the function button (including TV ?/1) for the component you want to control.
For example, if you are going to control a CD player, press CD/SACD.