Learning the commands of your components (continued)
5 Press the appropriate button on the remote control to be learned to send the remote button code.
Lightly pressing the button once should be sufficient.
If learning is completed successfully, the indicator slowly flashes twice and the remote automatically exits the learning mode.
When learning is not completed successfully, the indicator flashes 4 times in quick succession and the procedure returns to step 5.
If the memory of the remote is already full, the indicator flashes 8 times in quick succession and the remote automatically exits the learning mode.
Notes
•You can program more than 80 keys for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons. The number of buttons you can program for each FUNCTION button are shown in the following table.
FUNCTION button area | Number of Buttons |
| you can program |
|
|
VIDEO 1, VIDEO 2, | 78 keys |
DVD/LD |
|
|
|
VIDEO 3, TV/SAT, | 78 keys |
TAPE |
|
|
|
MD/DAT, CD/SACD, | 78 keys |
TUNER |
|
|
|
PHONO, MULTI CH | 52 keys |
|
|
TV buttons (TV ?/1, | 7 keys |
TV VOL |
|
WIDE, TV/VIDEO) |
|
|
|
•In steps 2 and 3, the indicator turns off while a valid button is pressed.
•In step 3, if several buttons that can be used for learning are pressed, only the last pressed button is valid. The indiactor blinks slowly, it turns ON while a valid button is pressed.
•In step 5, if a button that can be used for learning is pressed, the new button is selected and the learning procedure returns to the beginning of step 5.
To activate the function after programming.
Press the programmed button to activate the function you want.
To cancel learning
Press USE MODE during any step. The remote automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step 3, press
TV ?/1for more than 2 seconds. The indicator lights twice slowly and the learned code is cleared. If TV ?/1is pressed less than 2 seconds, the learning procedure returns to the beginning of step 5.
When a learned code is cleared, if the button was previously programmed for another function, the programmed code for that button can be used.
To clear the memory of the remote
To clear all programmed and learned signals, do the following to reset the remote to factory settings.
At the same time, press ?/1, AV ?/1, and
MASTER VOLUME.
The indicator flashes 3 times, then goes off.
To use a command that has been learned
When selecting a learned function, press the learned button for that function.