Troubleshooting (continued)

To connect an LD player via an RF demodulator.

Connect the LD player to the RF demodulator, then connect the RF demodulator’s optical or coaxial digital output to the receiver’s jack. When making this connection, be sure to set INPUT MODE manually (page 26). The receiver may not operate correctly if INPUT MODE is set to “AUTO 2CH”. For details on DOLBY DIGITAL RF hookups, see the operating instructions supplied with your RF demodulator.

The FM reception is poor.

Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Receiver

Outdoor FM antenna

ANTENNA

AM y

FM

Ground wire

(not supplied)

75Ω

COAXIAL

 

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 41).

•Press DISPLAY so that the frequency appears in the display.

There is no picture or an unclear picture appears on the TV screen or monitor.

•Select the appropriate function on the receiver.

•Set your TV to the appropriate input mode.

•Move your TV away from the audio components.

The remote does not function.

•The MPX/DUAL and 12 buttons on the remote are not available (RM-PG411 only).

•The AUX, SOURCE, MPX/DAUL, 12 and ON SCREEN buttons on the remote are not available (RM-PP411 only).

•Point the remote at the remote sensor g on the receiver.

•Check that the mode of the remote corresponds to that of the receiver (page 44 and 52).

•Remove any obstacles in the path between the remote and the receiver.

•Replace both batteries in the remote with new ones, if they are weak.

•Make sure you select the correct function on the remote.

•Press MAIN MENU on the remote before you use the V/v/B/b buttons for receiver operation (page 51).

Clearing the receiver’s memory

To clear

See

All memorized settings

page 19

 

 

Customized sound fields

page 39

 

 

60US