There is no sound from one of the front speakers.
Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones (page 27).
If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component.
If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.
The left and right sounds are unbalanced or reversed.
•Check that the speakers and components are connected correctly and securely.
•Adjust balance parameters in the LEVEL menu.
There is severe hum or noise.
•Check that the speakers and components are connected securely.
•Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light.
•Move your TV away from the audio components.
•Make sure you have grounded U SIGNAL GND terminal (only when a turntable is connected).
•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
There is no sound or only a very
•Make sure the sound field function is on (press MODE (SOUND FIELD)).
•Select a sound field containing the word “CINEMA STUDIO EX” (pages
•Adjust the speaker level (page 25).
•Make sure the center or/and surround speaker size parameter is set to either “SMALL” or “LARGE” (page 21).
There is no sound from the active sub woofer.
There is no sound output from the SUB WOOFER terminal depending on the sound field (page 67).
The surround effect cannot be obtained.
Make sure the sound field function is on (press MODE (SOUND FIELD)).
Dolby Digital or DTS multi channel sound is not reproduced.
•Check that the playing DVD, etc. is recorded in Dolby Digital or DTS format.
•When connecting the DVD player, etc. to the digital input jacks of this receiver, check the audio setting (settings for the audio output) of the connected component.
Recording cannot be done.
•Check that the components are connected correctly.
•Select the source component with FUNCTION control.
•Make sure that INPUT MODE is set to “ANALOG 2CH FIXED” before recording from a digital component connected to the analog MD/DAT or TAPE terminals
•Make sure that INPUT MODE is set to “COAXIAL FIXED” or “OPTICAL FIXED” (page 26) before recording from a digital component connected to the DIGITAL MD/DAT OUT terminals
continued
Information Additional