Assemble the TV Stand

WARNING

If you allow the mains lead to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the mains lead or the connecting cable, the TV Stand may topple over and cause injury.

Decide on the installation location and lay the TV Stand down before installing the TV.

Since the TV is heavy, it is recommended that you decide on the installation location and lay the TV Stand down before installing the TV.

1 Detach the front and rear pillar support panels from the centre pillar.

Rear pillar support panel

Front pillar support panel

2

3

Attach the centre pillar to the frame.

Secure the centre pillar to the frame with the four screws.

Screw Frame

Notes

•Be sure that two or more persons assemble the TV Stand.

•Loosely attach the centre pillar to the frame with the four screws, then tighten all screws sufficiently.

•When using an electric screwdriver, set the torque setting to approximately 1.5 N·m {15 Kgf·cm}.

As shown below, attach the front pillar support panel.

Note

Before attaching the front pillar support panel, check that the four screws are firmly tightened.

6 (GB)