Sony TA-VE700 manual 15EN, Advanced Remote Operations, Numeric button, Operates

Advanced Remote Operations

Operating One Component While Using Another (background operation)

You can temporality operate other components while listening to or watching a programme.

Numeric buttons

Changing the Factory Setting of a FUNCTION Button

If the factory settings of the FUNCTION buttons (page

9)don’t match your system components, you can change them. For example, if you connect a Sony LD player to the VIDEO 2 jacks, you can assign the VIDEO 2 button to set the remote to control the LD player.

Note that the settings of the TUNER and PHONO buttons cannot be changed.

BACKGROUND ￿

0 ) = +

1	Hold down BACKGROUND.
2	Press both the corresponding numeric button of
	the component you’re going to use (see the table
	below) and one of the following buttons at the

Numeric buttons

￿

0 ) = +

SYSTEM CONTROL/ FUNCTION

same time; VISUAL POWER, TV/VIDEO, CH

PRESET +/–, ANT TV/VTR, D.SKIP, (, 9, p,

0/), =/+, P, r.

Example:To start recording on a tape deck while

listening to a CD

While holding down BACKGROUND,

press 4 (or 5) and press r + ( at the

same time.

The numeric buttons are assigned to select the functions as follows:

Numeric button	Operates
1	CD player
2	DAT deck
3	MD deck
4	Tape deck A
5	Tape deck B
6	LD player
7	VCR (remote control mode VTR 1*)
8	VCR (remote control mode VTR 2*)
9	VCR (remote control mode VTR 3*)
0	TV

*Sony VCRs are operated with a VTR 1, 2 or 3 setting. These correspond to Beta, 8mm and VHS respectively.

1Holding down the SYSTEM CONTROL/ FUNCTION button whose function you want to change (VIDEO 2, for example).

2Press the corresponding numeric button of the component you want to assign to the SYSTEM CONTROL/FUNCTION button (6 - LD player, for example).

For the numeric buttons, see the table in “Operating One Component While Using Another.”

Now you can use the VIDEO 2 button to control your Sony LD player.

To reset the setting to the factory setting

Repeat the above procedure.

15EN