Sony TRV19, TRV22, TRV33 Step 2: Setting the VCR to operate, Dubbing only desired scenes – Digital program editing (on tape)

Dubbing only desired scenes – Digital program editing (on tape)Step 2: Setting the VCR to operate

When you are connecting the camcorder and VCR using the A/V connecting cable, the signal is emitted from the infrared rays emitter of your camcorder to the remote sensor on the VCR to control the VCR.

The POWER switch should be set to .

Operate by touching the panel.

(1) Turn the power of the connected VCR on. If the VCR has an input selector, set it to input.

When you connect a video camera recorder, set its power switch to VCR/ VTR.

(2) Press FN to display PAGE1.

(3) Press MENU to display the menu.

(4) Select VIDEO EDIT in , then press EXEC (p. 185).

(5) Select TAPE, then press EXEC (DCR-TRV22/TRV33 only).

(6) Press EDIT SET.

(7) Select CONTROL, then press EXEC.

(8) When connecting with the A/V connecting cable, select IR, then press EXEC. When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to “Step 3: Adjusting the synchronization of the VCR” on page 88.

(9) Select IR SETUP, then press EXEC.

(10) Select the IR SETUP code of your VCR, then press EXEC. Check the code in “About the IR SETUP code” (p. 87).

Editing

4		EXIT	5		6
OTHERS			V I DEO ED I T		0:32:30:14
DATA CODE
BEEP			MARK	START	ED I T UNDO
COMMANDER			IN		SET
D I SPL AY	RETURN
V I DEO ED I T
	TAPE
	MEMORY		TOTAL	0:00:00:00
			SCENE	0
	EXEC	RET.			END

7					9
	V I DEO ED I T			END		V I DEO ED I T			END
	ED I T SET		I R			ED I T SET
		CONTROL					CONTROL
		ADJ TEST	i. L I NK				ADJ TEST
		”CUT - I N”					”CUT - I N”
		”CUT -OUT”					”CUT -OUT”
		I R SETUP					I R SETUP	3
		PAUSEMODE					PAUSEMODE
		I R TEST					I R TEST
			EXEC	RET.				EXEC	RET.

V I DEO ED I T			END
ED I T SET		I R
	CONTROL

ADJ TEST

”CUT - I N”

”CUT -OUT”

I R SETUP PAUSEMODE I R TEST

EXEC RET.

85