Sony TTR1 manual Connect to a Wired Network Using Manual Settings, Is DHCP enabled or disabled?

Connect to a Wired Network Using Manual Settings

In order to connect to a wired network, you will need to have the following information to enter during the procedure:

Is DHCP enabled or disabled?

If disabled, the IP address to use for the Radio?

If disabled, the Subnet Mask IP address?

If disabled, the Gateway IP address?

If disabled, the Primary DNS IP address?

If disabled, the Secondary DNS IP address?

a.At the rear of the Radio, remove the compartment cover and connect an Ethernet cable to the Ethernet connector on the inside left of the compartment.. Refer to “Wired Ethernet Connector” on page 11 for the location of the Ethernet connector.. Replace the compartment cover..

b.Connect the other end of the Ethernet cable to your home’s wired network..

c.If you have just turned your SIRIUSXM TTR1 Radio on for the first time, the SSID screen will already be displayed.. Skip ahead to step f..

d.Press MENU and turn the TUNE knob to highlight System Setup.. Press the TUNE Knob..

e.Turn the TUNE knob to highlight Network.. Press the TUNE Knob..

f.Turn the TUNE Knob to highlight Manual Settings [Manual config].. Press the TUNE Knob..

71