For details on how to insert the batteries, see “Power Supply” on page 34.
g+ (+ selection) / – (– selection/reset) buttons
Press these buttons to set the transmission channel, frequency, or attenuation level of the input signal.
The
hSET button
Press to change and enter display parameters.
For details, see “Transmitter Settings” on page 46.
iDisplay section
The channel indication (E) for U30 model is shown.
AAF (audio frequency) indication Appears whenever the input audio signal is stronger than the reference level.
BRF (radio frequency) indication Appears during signal transmission from the antenna.
CRF (radio frequency) level indication
Shows the RF output level setting.
For details, see “Setting the RF output power level” on page 47.
DBATT (battery) indication Shows the battery condition.
For details, see “Battery indication” on page 35.
ECH (channel) indication
Shows the transmission channel. Each time you press the SET button in transmission mode, the channel indication changes as follows.
For details, see “Transmitter Settings” on page 46.
Transmission channel
Transmission | Press | |
frequency | ||
| the | |
Attenuation | SET | |
button. | ||
level of the | ||
| ||
input signal |
|
Accumulated use time
The channel/frequency indications for U30 model are shown.
The rear side of the battery compartment
28 | Parts Identification |
|
|