operate normally. Wait a few seconds before turning it on again.
Searching the available channels within the group (Clear Channel Scan)
The procedure below can be performed with the portable diversity tuner
Available channels within the specified channel group can be searched.
Before performing this procedure, select the channel group.
For details on channel group selection, see “Setting the reception channel” on page 42.
1 While pressing down the SET button, press the + button.
Keep both buttons pressed down.
2 Release the SET button and the + button after “SCAN +” appears and starts flashing.
3 Press the + button.
The tuner starts to scan through the selected channel group. When available channels are found, the first channel number among the available channels flashes in the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. The display shows the flashing “SCAN +” again.
To
Press the SET button again to display the flashing channel group indication, then select the channel group. And then, start from step 1.
4 While the desired channel number is flashing, leave the tuner for about 10 seconds or press down the SET button for more than one second.
Search finishes. The selected channel number stops flashing and the selection is stored in memory.
To start searching while performing settings
While the display section parameters are flashing, press the SET button repeatedly until “SCAN +” appears and starts flashing. Then, start from step 3 above.
Selecting the channels on multiple tuners automatically
The procedure below can be performed with the diversity tuner module
When multiple diversity tuner modules
1 Turn off all the microphones and transmitters.
44 Tuner Settings