Notes on the European model
Select the group number before selecting the channel number as follows.
1)While the left two digits are flashing, select the group number by pressing the + or – button.
2)While the desired group number appears, press the SET button. The right four digits start to flash to allow the selection of the channel number.
3)Select the channel number by pressing the + or – button.
Group | Channel | Frequency |
selection | selection | selection |
V: + button | v: – button |
Group, channel, and frequency selection examples for CE62 model are shown.
4 When the desired channel number (or frequency) appears, set the POWER switch to OFF to complete the setting, or press the SET button to set other items.
The results are stored in memory. The stored channel number (or frequency) will appear in the display section the next time you turn on the transmitter by setting the POWER switch to ON.
Notes
•When you are setting the transmission channel, the transmitter cannot be used to transmit signals.
•Do not remove the batteries while setting the transmission channel. If they are inadvertently removed,
•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.
•If you turn off the transmitter and then immediately turn it on right after setting the transmission channel, the unit may not operate normally. Wait a few seconds before turning it on again.
Setting the RF output power level
The procedure below can be performed with the
You can select the RF output power level from “H” (30 mW) or “L” (5 mW) in setting
mode Set the RF output level to L (5 mW) for simultaneous operation of multiple channels, and set it to H (30 mW) for
1 Turn on the transmitter while pressing down the SET button.
2 Press the SET button repeatedly until the RF output level indication appears in the display section.
3 Press the + button to select “H” (30 mW), or press the – button to select “L” (5 mW).
Transmitter Settings | 47 |
|
|