Sony V2, V6 Troubleshooting

Troubleshooting

If you have any problem using the UWP series components, use the following checklist. Should any problem persist, consult your Sony dealer.

Symptom	Meanings	Remedy
The unit does	The polarity orientation of the	Insert the batteries with the correct
not turn on.1)	batteries in the battery	polarity orientation.
	compartment is incorrect.
	The batteries are exhausted.	Replace the batteries with new ones.
	The battery terminals in the	Clean the + and – terminals with a
	transmitter are dirty.	cotton swab.
The batteries	The batteries are exhausted.	Replace the batteries with new ones.
become
	Manganese batteries are being	Use alkaline batteries. The battery
drained
	used.	life of a manganese battery is less
quickly.1)
		than half that of an alkaline battery.
	The UWP series components is	The batteries drain quickly under
	being used under cold	cold conditions.
	conditions.
The channel	An attempt was made to	Restart the unit while holding down
cannot be	change the channel by pressing	the SET button. Then change the
changed.	the SET button only.	channel with the + and – buttons.
There is no	The channel setting on the	Use the same channel setting on
sound.	transmitter is different from that	both the transmitter and tuner.
	on the tuner.
	The RF indicator on the tuner	Confirm that the transmitter is turned
	does not turn on.	on.
	The line input is selected on the	Select the microphone input on the
	transmitter.2)	transmitter.
The sound is	The attenuation level on the	The input level of the transmitter is
weak.	transmitter is too high.	low. Press the + button on the
		transmitter in attenuation level
		setting mode to decrease the
		attenuation level.
	The volume on the amplifier or	Adjust the volume.
	mixer is low.
	The line input is selected on the	Select the microphone input on the
	transmitter.2)	transmitter.

54 Troubleshooting