2 Select the channel group on the tuner module installed into the slot 1of the
3 After confirming that the channel group indication has stopped flashing (about 10 seconds after you have selected the channel group), keep pressing the + button on the tuner module installed into the slot 1of the
All the tuner modules installed into the
After the automatic detection and selection of available channels finish, you can change the group and channel on each tuner module manually.
Notes
•Do the automatic detection and selection of available channels with the channel group other than channel group 00.
•When there are unavailable channels due to extraneous radio wave and the channel could not be selected on some tuner modules, “NO CH” appears on the display of those tuner modules. If this happens, select the channel group with no interference from extraneous radio wave, and repeat the procedure above.
Setting the monitor level
The procedure below can be performed with the portable diversity tuner
You can set the monitor level for monitoring the tuner output within the range of 01 to 24.
1 While the parameters on the display section are not flashing, press the + or
– button once.
The monitor level indication appears in the display section.
2 Press the + button to increase the monitor level, or press the – button to decrease the level.
When you leave the tuner for about two seconds or more or press down the SET button for more than one second, current monitor level setting is stored in memory and the normal display resumes. Note that monitor level setting is effective after you turn off the tuner, then turn it on again.
Resetting the accumulated use time indication
The procedure below can be performed with the portable diversity tuner
The accumulated use time is the total time (in hours and minutes) that the tuner has been used. It is recorded whenever the tuner is on.
If you reset the indication to “00:00” when you replace the batteries, this shows the accumulated battery use time.
1 Press down the SET button for more than one second.
Keep pressing the SET button until the display section parameters start to flash.
2 Press the SET button repeatedly until the accumulated time indication appears in the display section.
Tuner Settings 45