BMaintenance
Maintenance
Replacing the Lamp

Replace the lamp with a new one in the following case.

•When the lamp has burnt out or dims

•“Please replace the LAMP.” appears on the screen

•The LAMP/COVER indicator lights up The lamp life varies depending on conditions of use. Use LMP-C150 Projector Lamp as the replacement lamp.

When replacing the lamp after using the projector

Turn off the projector, then unplug the power cord.

Wait for at least an hour for the lamp to cool.

Caution

The lamp becomes a high temperature after turning off the projector with the I / 1 key. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least an hour for the lamp to cool.

Notes

•If the lamp breaks, consult with qualified Sony personnel.

•Pull out the lamp by holding the handle. If you touch the lamp, you may be burned or injured.

•When removing the lamp, make sure it remains horizontal, then pull straight up. Do not tilt the lamp. If you pull out the lamp while tilted and if the lamp breaks, the pieces may scatter, causing injury.

1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.

Note

Be sure that the projector is stable after turning it over.

2 Open the lamp cover by loosening a screw with the Phillips screwdriver (supplied with the Projector Lamp).

 

Note

 

 

 

 

 

For safety sake, do not loosen any other

 

 

 

 

 

 

 

 

screws.

 

 

 

 

 

 

 

 

 

 

 

3

Bottom

Maintenance

Loosen the three screws on the lamp

 

unit with the Phillips screwdriver. Pull out the lamp unit by the handle.

Screws on the lamp (3)

Handle

Maintenance 41 GB