Other Functions
Off & Go Function
If you are leaving the conference room immediately, turn the projector off, and then, after the powered tilt adjuster is retracted into the projector, you can unplug the AC power cord. After the AC power cord is unplugged, the fan runs for a certain time automatically.
Notes
•When unplugging the AC power cord, ensure that the powered tilt adjuster has been retracted into the projector. Moving the projector with the powered tilt adjuster extended may damage the adjuster.
•Turn off the projector according to the procedure explained in ““Turning Off the Power” on page 14,” then cool it down before storing the projector in the carrying case.
•However, if the unit has been on for less than 15 minutes, the fan might not begin to turn as a result of inadequate charging. In that case, follow the procedure for turning off the power as described in “Turning Off the Power” on page 14.
Effective Tools for Your Presentation
To enlarge the image (Digital Zoom function)
You can select a section of the image to enlarge. This function works when a signal from a computer is input.
This function does not work when a video signal is input.
1 Project a normal image, and press the D ZOOM + key on the Remote Commander.
The digital zoom icon appears in the center of the image.
Digital zoom icon
2 Move the icon to the point on the image you want to enlarge. Use the arrow key (v/V/b/B) to move the icon.
3 Press the D ZOOM + key again.
The portion of the image where the icon is located is enlarged. The enlargement ratio is displayed on the screen for a few seconds.
By pressing the + key repeatedly, the image size (ratio of enlargement: max. 4 times) increases.
18 Other Functions