Symptom

Cause and Remedy

 

 

The picture is noisy.

Noise may appear on the background depending on the combination

 

of the number of dots input from the connector and the numbers of

 

pixels on the LCD panel.

 

c Change the desktop pattern on the connected computer.

 

 

The picture from the

The setting of “Input-A Signal Sel.” on the Setup menu is incorrect.

INPUT A connector is

c Select “Auto”, “Computer,” “Video GBR” or “Component”

colored strangely.

correctly according to the input signal (see page 29).

 

 

“Please check Input-A

The setting of “Input-A Signal Sel.” on the Setup menu is incorrect.

Signal Sel.” appears in

c Select “Auto”, “Computer,” “Video GBR” or “Component”

spite of inputting the

correctly according to the input signal (see page 29).

correct signal from

 

INPUT A.

 

 

 

On-screen display does not

“Status” on the Setup menu has been set to “Off.”

appear.

c Set “Status” on the Setup menu to “On” (see page 29).

 

 

Color balance is incorrect.

• The picture has not been adjusted properly.

 

c Adjust the picture (see page 22).

 

• The projector is set to the wrong color system.

 

c Set “Color System” on the Setup menu to match the color

 

system being input (see page 29).

 

 

The picture is too dark.

• Contrast or brightness has not been adjusted properly.

 

c Adjust the contrast or brightness on the “Adjust Picture...” menu

 

of the Picturem menu properly (see page 22).

 

• The lamp has burnt out or is dim.

 

c Replace the lamp with a new one (see page 32).

 

 

The picture is not clear.

• The picture is out of focus.

 

c Adjust the focus (see page 13).

 

• Condensation has accumulated on the lens.

 

c Leave the projector for about two hours with the power on.

 

 

The image extends beyond

The APA key has been pressed even though there are black edges

the screen.

around the image.

 

c Display the full image on the screen and press the APA key.

 

c Adjust “Shift” on the Adjust Signal... menu of the Signal menu

 

properly (see page 23).

 

 

The picture flickers.

“Dot Phase” on the Adjust Signal... menu of the Signal menu has not

 

been adjusted properly.

 

c Adjust “Dot Phase” on the Adjust Signal... menu of the Signal

 

menu properly (see page 23).

 

 

36 Troubleshooting