Connecting the

Projector

When you connect the projector, make sure to:

•Turn off all equipment before making any connections.

•Use the proper cables for each connection.

•Insert the cable plugs firmly; loose connections may increase noise and reduce performance of picture signals. When pulling out a cable, be sure to pull it out by the plug, not the cable itself.

Connecting a Computer

This section describes how to connect the projector to a computer.

For more information, refer to the computer’s instruction manual.

To connect a computer

Right side

to audio output

Computer

to monitor output

Picture the Projecting

AStereo audio connecting cable (not supplied) (Use a no-resistance cable.)

BHD D-sub 15-pin cable (supplied)

Notes

•The projector accepts VGA, SVGA, XGA, SXGA, and SXGA+ signals. However, we recommend that you set the output mode of your computer to XGA mode for the external monitor.

•If you set your computer, such as a notebook computer, to output the signal to both your computer’s display and the external monitor, the picture of the external monitor may not appear properly. Set your computer to output the signal to only the external monitor.

Connecting the Projector

15