Sony VPL-CX63 Projecting, Notes, to display, Press INPUT, To input from

LCD / VGA ,

Projecting

VPL-CX63

ON/STANDBY indicator

Rear remote control detector

APA	INPUT
KEY
STONE	/TILT
LENS		ENTER
AUTO	RESET	MENU
FOCUS
FREEZE
	D ZOOM	VOLUME
PIC		AUDIO
MUTING		MUTING

1 Plug the AC power cord into a wall outlet, then connect all equipment.

The ON/STANDBY indicator lights in red and the projector goes into standby mode.

2 Press the ?/1 key.

The ON/STANDBY indicator flashes in green.

3 Turn on the equipment connected to the projector.

4 Press the INPUT key to select the input source.

Each time you press the key, the input signal switches as follows:

Input-AtInput-BtVideotS-Video

To input from	Press INPUT
	to display
Computer connected to	Input-A
the INPUT A connector
Computer connected to	Input-B
		Projecting
the INPUT B connector
Video equipment	Video
connected to the VIDEO
input connector		the
Video equipment	S-Video
		Picture
connected to the
S VIDEO input
connector

Smart APA (Auto Pixel Alignment) adjusts the picture of the connected equipment so that it is projected clearly.

Notes

•If “Auto Input Search” is set to “On,” the projector searches for the signals from the connected equipment and displays the input channel where the input signals are found.

For details, see “Auto Input Search” on page 29.

•The Smart APA feature is effective for the input signal from a computer only.

5 Switch the equipment connected to output to the projector.

Depending on the type of your computer, for example a notebook, or an all-in-one LCD type, you may have to switch the computer to output to the projector by pressing certain keys (e.g.,

/ , etc.), or by changing

your computer’s settings.

Projecting 17