F7 or Fx

and

Fn

Note

The key used for switching the computer to output to the projector varies depending on the type of computer.

6 Adjust the upper or lower position of the picture.

Use the adjuster to adjust the picture position.

Using the adjuster

Lift the projector while pressing the adjuster adjustment button, and adjust the tilt of the projector, then release the button at the locked position.

displays on the screen, and adjust the value with the v/V/b/B keys. The corrected value is effective until the power is turned off.

•Be careful not to let the projector down on your fingers.

•Do not push hard on the top of the projector with the adjuster extended. It may cause a malfunction.

7 Adjust the size of the picture and the focus.

To adjust using the RemoteCommander

Select the item to be adjusted by pressing the LENS key, then adjust with the v/V/b/B key. Each time you press the key, the menu toggles between Lens Focus and Lens Zoom in order.

To adjust using the control panel Press the ZOOM +/– keys on the projector to adjust the size of the picture and press the FOCUS +/– keys to adjust the focus.

Adjuster adjustment button

Notes

•When you adjust the tilt of the projector with the adjuster, the V keystone adjustment is performed at the same time. If you do not want to perform the automatic keystone adjustment, set the V Keystone menu to “Manual.” (See page 32.)

If you set the “V Keystone” adjustment to “Auto,” the “V Keystone” correction is automatically adjusted. However, it may not be perfectly adjusted depending on the room temperature or the screen angle. In this case, adjust it manually. Press the KEYSTONE/TILT key on the Remote Commander to “V Keystone”

18 Projecting