Projecting
ON/STANDBY indicator
|
| INPUT |
|
MENU | HELP |
|
|
ENTER | RESET | APA | LIGHT |
|
|
Rear remote control detector
1 After all equipment is connected completely, plug the AC power cord into the wall outlet.
The ON/STANDBY indicator lights in red and the projector goes into the standby mode.
2 Press the I / 1 key.
The ON/STANDBY indicator lights in green.
3 Turn on equipment connected to the projector. Press the INPUT key to select the input source.
Projecting
VIDEO: Selects audio and video signals input from the AUDIO/VIDEO (VIDEO IN) jacks.
Note
The AUDIO (VIDEO IN) jacks are used as audio outputs of both VIDEO and
4 Turn the zoom ring to adjust the size of the picture.
5 Turn the focus ring to adjust the focus.
Note
Looking into the lens when projecting may cause injury to your eyes.
ToPress
Adjust the volume the VOL +/– keys on the control panel or the VOLUME +/– keys on the Remoter Commander.
Cut off the sound the AUDIO MUTING key on the Remote Commander. To restore the sound, press the AUDIO MUTING key again or press the VOL + key on the control panel or the VOLUME + key on the Remote Commander.
Cut off the picture the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again.
To get the clearest pictureYou can get the suitable picture when a signal from the computer is input. Press the APA key.
The picture is automatically adjusted to be projected clearest.
Notes
•Adjust the signal when the still picture is displayed on the screen.
•Press the APA key when the full image is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen.
•If you switch the input signal or
19 (GB)