Projecting
•“ADJUSTING” appears on the screen. Press the APA key again during the adjustment to restore the original screen.
•“Complete!” appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals.
•Adjust the items in the INPUT SETTING menu when you adjust the picture manually.
For details, see page 24 (GB).
To correct the trapezoidWhen the projecting image is a trapezoid, change the projector’s position/height by moving the adjuster.
For details on “How to use the adjuster”, see page 10 (GB).
If the image is still a trapezoid, correct it in DIGIT KEYSTONE in the INSTALL SETTING menu.
When the base edge is longer than the upper edge as shown in the figure below:
Set the value to negative.
When the upper edge is longer than the base edge as shown in the figure below:
Set the value to positive.
For details on “DIGIT KEYSTONE”, see page 27 (GB).
1 Press the I / 1 key.
“Power OFF?” appears on the screen.
Note
The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds.
2 Press the I / 1 key.
The ON/STANDBY indicator flashes in green and the fan continues to run for about 120 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 40 seconds. During this time, you will not be able to turn the power back on with the I / 1 key.
3 Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red.
When you cannot confirm the
When you cannot confirm the
Note
Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop although the internal heat is still high, leading to breakdown of the projector.
About the air filter cleaningClean the air filter every 300 hours to ensure
optimal performance.
20 (GB)