
ELECTRONIC SHUTTER
∙Using trigger pulse width
•Set DIP switches 1 to 4 on the rear panel to 0.
•An arbitrary shutter speed can be obtained by setting the trigger pulse width to the range of 2 μsec to 250 msec.
Switch | Mode 1 | Mode 2 | |
(Reset mode) | |||
| |||
|
|
| |
1 | 0 | 0 | |
2 | 0 | 0 | |
3 | 0 | 0 | |
4 | 0 | 0 | |
5 | Frame: 0 | / Field: 1 | |
6 | 0 | 0 | |
7 | 1 | 0 | |
8 | 1 | 1 | |
9 | 0 | 0 | |
0 | 0 | 0 |
Exposure time = Trigger pulse width + 97 | μsec (EIA) |
120 | μsec (CCIR) |
Note : 1. lt is recommended to set DIP switch 5 for field selection.
(The field selection is about two times in sensitivity as high as the frame selection.)
2.After a trigger pulse is input, a new trigger pulse must not be input before the video signal obtained by the trigger pulse has been output.
1:ON
0:OFF
Specifications of trigger pulse
T
A:4 to 5.0 V
B:0 to 1.0 V
T:2 ∝s to 1/4 s
A
B
T: 2 μs to 1/4 s, 100 μs to 1/4 s when setting the shutter speed using DIP switch
*Input impedance: 10 kW or more
*The voltage and pulse width used are measured at pin 11 of a
9