LOCATION OF PARTS AND OPERATION
XC-ES50/50CE .XC-ES30/30CE
XC-EI50/50CE .XC-EI30/30CE
2
4
1 
2 3 | 3 |
1Lens mount section (C mount)
A commercial
Sony standard lens can be used.
2Camera mounting reference hole
(top)
These screw holes are positionned with
high precision related to CCD sensor.
3Camera mounting reference hole/Screw hole for tripod adaptor mounting (bottom)
4
DC IN/HD/VD (DC power/sync signal
input) VIDEO OUT terminal
575 Ω termination selector switch
6HD/VD
4 
7
8
7Shutter speed/mode setting DIP
switch
Switches 1 to 4:
56
| External HD/VD | Internal HD/VD |
Pin No. | synchronization | synchronization |
| ||
1 | GND | GND |
2 | +12 V | +12 V |
3 | GND | GND |
4 | VIDEO output | VIDEO output |
5 | GND | GND |
6 | External HD input | Internal HD output |
7 | *1 External VD input | Internal VD output |
8 | GND | GND |
9 | – | – |
10 | *2 WEN output | *2 WEN output |
11 | TRIG input | TRIG input |
12 | GND | GND |
|
| *1: An input VD signal is required when the restart/reset mode is used. | ||
|
| *2: A WEN output signal is valid only in the external trigger shutter mode. | ||
∙ |
| |||
Corresponding |
| Switch | ||
No. |
| mode | ||
|
| |||
|
|
|
| |
5 | 75 Ω termination selector switch | ON | ||
6 | HD/VD | EXT | ||
7 | Shutter speed/mode setting DIP switch |
| ||
| Switches 1 to 4: Select the shutter speed. | OFF | ||
| Switch 5: Selects the frame or field integration. | FRAME | ||
| Switches 6 to 8: Select the trigger shutter mode. | Normal | ||
| Switch 9: Selects correction on/off. | OFF | ||
| Switch 0: Selects the gain. | Manual | ||
8 | Volume control switch | Mechanical | ||
center | ||||
|
|
| ||
Select the shutter speed. Switch 5: Selects the frame or field
integration.
Switches 6 to 8:
Select the trigger shutter mode.
Switch 9: Selects γ correction on/off.
Switch 0: Selects the gain.
8Volume control switch
This switch can be changed in the range of Switch 0 to 18 dB when the GAIN switch is set to “M”.
*During factory setting, this switch is adjusted to the mechanical center.
n
When setting DIP switch 5 to the frame integration, set the volume control switch 8 to the MAX side from the mechanical center (because of CCD characteristics).
5
