5Press f or g to set the timer-activated duration, then press SET.

With each press, the timer-activated duration changes in 5-minute steps between 5 to 240 minutes.

6Press for gto adjust the volume for timer playback, and press SET.The volume level can be adjusted from 0 to 35.

7Prepare the source. To play CD, load a disc.

To play a tape, insert the tape.To play the radio, select the band and tune in the desired station.

To play external equipment connected to the AUX IN jacks, set an external timer for the equipment so that its playback begins at the same time.

8Press POWER 6STANDBY/ON (POWER) to turn the unit off.

"5" remains on the display to indicate the timer standby mode (when ECO mode is deactivated).

At timer-on time, the unit turns on and plays the selected source. After the specified timer-activated duration, the unit turns off again.

•Timer playback will not begin unless the unit is turned off first.

•Connected equipment cannot be turned on or off by the built- in timer of this unit. Use an external timer.

Timer recording

Timer recording is available only for TUNER and AUX (with an external timer) sources.

1Hold down SHIFT and press TIMER on the remote control repeatedly so that "5REC" lights up and "5 REC" is displayed.

2Within 8 seconds, press SET.

3Press for g to set the timer-on time, and press SET.

Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.

4Press for gto select the source, and press SET.

•For timer recording of a radio broadcast, select "TUNER". You will select the band later in step 7.

•For timer recording of the equipment connected to the AUX IN jacks, select "AUX".

5Press f or g to set the timer-activated duration, then press SET.

With each press, the timer-activated duration changes in 5-minute steps between 5 to 240 minutes.

6Press for gto adjust the volume for timer recording, and press SET.

The volume level can be adjusted from 0 to 35.

7Prepare the source.To record the radio, select the band and tune in the desired station.

To record external equipment connected to the AUX IN jacks, set an external timer for the equipment so that its playback begins at the same time.

8Insert the recording tape and then turn the unit off.

"5 REC" remains on the display to indicate the timer standby mode (when ECO mode is deactivated).

At timer-on time, the unit turns on and records the selected source. After the specified timer-activated duration, the

unit turns off again.

•Connected equipment cannot be turned on or off by the built- En in timer of this unit. Use an external timer.

To check the timer setting

Hold down SHIFT and press TIMER on the remote control repeatedly so that "5 PLAY" or "5 REC" appears on the display.

The timer-on time, the source and the timer-activated duration are displayed for 8 seconds.

To change the timer settingReset the timer again.To cancel the timer

Hold down SHIFT and press TIMER on the remote control repeatedly until "5 OFF" is displayed. "5" or "5 REC" disappears from the display.

Tip:

Your timer setting is retained even if the timer is canceled. Next time the timer is activated, you can change your previous setting, or simply use the same setting again.

17