Problem | Causes/measures | |
|
|
|
| “The internal temperature of the | If you use this unit at |
| device is too high.” appears, and | internal temperature of the unit may become too high. Turn off |
| the unit enters standby mode. | the unit, wait for a while until it cools down, and then turn on |
| The On/Standby indicator | again. |
| flashes (no message appear on |
|
| the display while the unit is in |
|
| the standby mode). |
|
“An error has occurred in the | The system’s automatic protection function has activated. | |
internal system.” appears and the | Disconnect the AC power adaptor, wait about 30 seconds, and | |
unit enters standby mode. | then reconnect it. | |
Connecting the unit to the network using AOSS
Problem | Causes/measures |
|
|
“No wireless station/access point | The AOSS button on the wireless station/the wireless LAN access |
in AOSS mode found.” appears. | point has not been pressed. Do the AOSS setup again. |
| Place the unit and the wireless station/the wireless LAN access |
| point close to each other and do the AOSS setup again. |
|
|
“An error occurred while | There was an information exchange failure between the unit and |
transferring AOSS information.” | the wireless station/the wireless LAN access point. Wait a while, |
appears. | and then do the AOSS setup again. |
“An error occurred in security Place the unit and the wireless station/the wireless LAN access
information.” appears. | point close to each other and do the AOSS setup again. |
“An error occurred while transferring security key.” appears.
“Another device is connected to | The AOSS setup is being performed for another device. Wait a |
the access point. Try again later.” | while, and then do the AOSS setup again. |
appears. |
|
|
|
“Multiple wireless stations/access | Multiple wireless stations/wireless LAN access points in AOSS |
points in AOSS mode found. Try | mode were detected. Wait a while, and then do the AOSS setup |
again later.” appears. | again. |
|
|
Troubleshooting
37GB