36 | BIOS Setup |
IR Transmission Delay | Choose Enabled (default) or Disabled. |
| Due to the various design of IR devices, |
| transmission delay has to be added on |
| for different protocol. |
IR IRQ Select | Choose IRQ3, IRQ4 (default), IRQ10, or |
| IRQ11. If you have IRQ conflict |
| problem during using the IR device, |
| select another IRQ then try again. |
FIR Mode Use DMA | Choose Disabled, 0, 1, or 3. When you |
| choose FIR in IR Mode, you need to |
| select a DMA channel to make the FIR |
| transmission work. |
Onboard Parallel Port | Choose the parallel port I/O address: |
| 378H/IRQ7 (default), 3BCH/IRQ7, |
| 278H/IRQ5, or Disabled to disable this |
| port. |
Parallel Port Mode | Choose ECP+EPP (default), SPP, EPP, |
| or ECP. The mode depends on your |
| external device that connects to this port. |
ECP Mode Use DMA | Choose DMA3 (default) or DMA1. |
| This setting only works when the |
| Onboard Printer Mode is set at the ECP |
| mode. |
EPP Mode Select | Choose EPP1.9 (default) or EPP1.7. |
| Check with your parallel port device |
| provider to select the right mode. |
3.After you have finished with the Integrated Peripherals, press the <ESC> key and follow the screen instructions to save or disregard your settings.
