![](/images/new-backgrounds/1183798/18379847x1.webp)
Hardware Setup |
|
Warning: Follow these precautions to preserve your
Motherboard from any remnant currents when connecting
to ATX power supply:
Turn off the power supply and unplug the power cord
of the ATX power supply before connecting to ATX PW
connector.
The Motherboard requires a power supply with at least 200 Watts and a "power good" signal. Make sure the ATX power supply can take at least 10 mA* load on the 5V Standby lead (5VSB) to meet the standard ATX specification.
*Note: If you use the
sure the ATX power supply can support at least 720 mA on the 5V Standby lead (5VSB).
Please install the ATX power according to the following pin assignment:
ATX Power
12V
5VSB
GND
5V
GND
5V
GND
3.3V
3.3V
5V |
| |
5V |
| |
| ||
GND |
| |
GND | Ø Pay special care to the directionality. | |
GND | ||
| ||
| ||
GND |
| |
| ||
3.3V |
|
21