Ultra SCSI I/O Subsystem | SY-D6IBA |
5-3 CONNECTING INTERNAL SCSI DEVICES
If you are connecting several internal SCSI devices (more than 2 CD-ROM drives), make sure you have an internal SCSI cable with enough connectors to accommodate all of your devices. The enclosed SCSI flat cables can serve up to 2 CD-ROM drives.
Follow these steps to ensure a proper installation of your internal SCSI devices:
1.Prepare each CD-ROM drive for installation; configure the device SCSI ID and terminators (terminate the last internal device attached to the cable by setting its termination to the ON position; all other internal devices on the SCSI bus must have their termination set to OFF).
2.Install the CD-ROM drive in your computer.
3.Plug the connector at one end of the internal SCSI cable into the host adapter’ s SCSI connector on the Motherboard.
Note: Make sure the cable’ s colored stripe is aligned with pin-1 of the host adapter’ s connector. Pin-1 of the SCSI connector is usually designated by a small triangle (s ), or a “1” at one corner of the connector.
4.Connect the remaining connectors on the cable to the SCSI devices (CD-ROM drives, etc.).
Note: Make sure the cable’ s colored stripe is aligned with pin-1 of the SCSI device’ s connector.
5.Connect a DC power cable (from your computer’ s power supply) to the power connector on each SCSI device.
