SOYO SY-KT600 DRAGON Plus Quick Start Guide CMOS Clear JP5, On-board Speaker connection

Hardware Installation

SY-KT600 DRAGON Plus Quick Start Guide

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear the CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. Its white cap can easily identify this jumper.

2.Put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing	Clear CMOS Data			Retain CMOS Data
	Short pin 2-3 for			Short pin 1-2 to
JP5 Setting	at least 5 seconds to
				retain new settings
	clear the CMOS
		2	1	3	2	1
	3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

On-board Speaker connection

When using 2-channel speaker, connect the speaker cable to Line-out.

If you’re using 4 channel speaker, connect the front L/R speakers to Line-out and rear L/R speakers to Line-in. Make sure that the audio software is set for 4 channel speaker system.

If you are using 6 channel speaker, connect the front L/R speakers to Line-out and the rear L/R speakers to Line-in. Connect the Center/Bass to Mic-in.

Line-in

Line-out

Mic-in

18