SpectraLink BPX100 Basic Operation, Seconds if another key is not pressed within that period

SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide

Basic Operation

Turn the handset on Press and hold the Power On key for about one second, until two chirps sound. Release the key. The in-service tone sounds and the extension number displays. The handset is now in standby mode, ready to make and receive calls.

Turn the handset off

Make a call or go off hook

Select a line

While in standby mode, press and hold the Power Off key. One chirp sounds and the handset turns off. The handset cannot be directly turned off during a call. End the call first and then turn the handset off.

Press the Start Call key and then dial the number.

If multiple lines are available, your telephone system may require you to select a line before dialing a number. Press the LINE key and the number key of the line you wish to use. You may hear a dial tone.

Dial a number	Dial calls with the handset exactly as with your desk phone. You
	may dial extension numbers, internal numbers, or make external
	calls, depending on the setup of your PBX. You may hear a dial
	tone, then press the number keys to dial the number.
Answer a call	The handset will ring or vibrate to alert you to an incoming call.
	Additionally, a line number on the display may flash, and the display
	may show information about the call, such as caller’s name and
	extension.
	To answer a call, press the Start Call key, hold the earpiece to your
	ear and speak with a normal tone of voice.
	If you are on a call and hear subdued ringing, a call is coming in on
	a second line. The line number on the display may be flashing. To
	answer this call, put your first call on hold and press the LINE key,
	then press the line number of the second call.
Headset answer	When a headset is plugged into the handset, the Start Call, 0 – 9, *
	or # key may be pressed to answer a call.
Hang up	To hang up, press the End Call key. Be sure to do this at the end of
	each call.
Unlock Keypad	Press the Unlk softkey, then #, to unlock the keypad.
Lock Keypad	Press FCN, then Select, to activate Lock Keys on the Standby Menu.
Change speaker volume	You may increase or decrease the volume of the speaker while in a
	call by pressing the corresponding Up and Down buttons located on
	the left side of the handset.
Change ring volume	You may increase or decrease the ring volume on the NetLink i640
	Wireless Telephone by pressing the corresponding Up and Down
	buttons located on the left side of the handset while it is ringing.
Silence while ringing	You may silence a ringing handset by pressing the End Call button.
	This action does not interrupt the call and the caller may leave a
	voicemail message.
Backlight	The backlight comes on when any key is pressed or when there is an
	incoming call and stays on for ten seconds. It turns off after ten
	seconds if another key is not pressed within that period.

Part Number: 72-1004-01-H.doc Page 9