General Maintenance

1.Wipe down all areas in the sweat path with a damp cloth after each workout.

2.If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:

I.i.The hardware was not sufficiently tightened during assembly. All bolts that were installed

during assembly need to be tightened as much as possible. It may be necessary to use a larger wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough; 90% of calls to the service department for noise issues can be traced to loose hardware or the rear rails

being dirty.

II.ii. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from build-up on the rails can cause a thumping sound that you would swear is coming from inside the main body of the machine because noise travels, and is amplified, in the tubing of the frame. Clean the rails and wheels with a lint free cloth and rubbing alcohol. Stubborn build-up can be removed with your thumbnail or a non-metallic scraper, like the back edge of a plastic knife. After cleaning, apply a small amount of lubricant on the rails with your fingers or a lint free cloth.You only need a thin coat of lubrication, wipe off any excess.

3.If squeaks or other noises persist, check that the unit is properly leveled.There are 4 leveling pads on the bottom of the rear rails, use a 14mm wrench (or adjustable wrench) to adjust the levelers.

Engineering Mode Menu

The console has built in maintenance/diagnostic software.The software will allow you to change the console settings from English to Metric and turn off the beeping of the speaker when a key is pressed for example.To enter the Engineering Mode Menu, press and hold down the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds and the Message Center will display Engineering Mode Menu. Press the Enter button to access the menu below:

a.Key Test (Will allow you to test all the keys to make sure they are functioning)

b.Security (Allows the keypad to be locked to prevent unauthorized use)

c.Functions (Press Enter to access settings and Up arrow to scroll)

i.Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)

ii.Incline On/Off (For e•Glide this is always off)

iii.Unit Type (Should show Elliptical, other setting is e•Glide. Switches calorie formula, HR program settings and watt tables for the different units)

iv.Motor Test (Press Enter to run the resistance motor up and down in a continuous loop. Display shows level setting and position sensor reading. Press stop to end test.)

v.Beep (Turns off the speaker so no beeping sound is heard)

vi.Units (Sets the display to readout in English or Metric display measurements)

vii.ODO Reset (Resets the odometer)

viii.Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)

d.LCD Test (Tests all the display functions)

XE395 Elliptical Trainer

26

Page 30
Image 30
Spirit XE395 owner manual General Maintenance, Engineering Mode Menu