Spirit XE395 owner manual Swing Arms, #103 mm

STEP2:Swing Arms

1.Place two Wave Washers (103) onto the left and right Console Mast shafts; Slide the left (10) and right (11) swing arms onto the shafts and secure with two Hex Head Bolts (74) and two Flat Washers (99); tighten with the wrench (129). Note: make sure the arms are placed on their respective shafts as shown in the illustration.

2.Slide a grommet (145) onto the left cable (146-1); connect that cable to the cable (147) of the left swing arm (10); snap the grommet into the hole on the side of the console mast tube, then push the excess amount of cable through the grommet. Repeat this process on the right side,

connecting cables (146 & 147).

3.Match the Front Handle Bar Cover (L) (68) with Rear Handle Bar Cover (L) (68-1) on left Swing Arm (10) and secure with three Sheet Metal Screws (107).Tighten using the Phillips Head Screw Driver (126). Repeat for the right Swing Arm (11), matching covers (69 & 69-1).

HARDWARE

#103. 17mm	#99. 5/6” x 23 x 1.5T	#107. 3.5 x 12mm	#74. 5/6” x 15mm	#145. Grommet
Wave Washer	Flat Washer	Sheet Metal Screw	Hex Head Bolt	(2 pcs)
(4 pcs)	(2 pcs)	(6 pcs)	(2 pcs)
XE395 Elliptical Trainer		8