38 |
The headlight
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, part no.
How to replace
Disconnect cleaner from electrical outlet.
38Using a screwdriver, remove the two screws as shown and lift off lens.
39
39Pull old bulb straight out of socket. Push new bulb straight
into socket until locked into place.
Excessive force is not required.
40 |
40Reposition the lens and secure with the two screws.
The belt
The belt on your cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition.
When to replace
To check belt, remove bottom plate and hood as shown in “How to replace belt.” Replace belt if it is stretched, cut or broken.
What to buy
To assure effective operation, use only genuine Triple S belts with your cleaner. When purchasing a new belt, ask for part no.
41 |
A |
How to replace
Disconnect cleaner from electrical outlet.
Place handle in low position and turn cleaner over so bottom side is up.
Remove the 4 screws as shown
41with a Phillips head screw driver. Lift off bottom plate (A).
42
42Remove agitator and used belt. Discard used belt.
Continued
9
