4.OPERATION
4.1INITIAL SETUP
NOTE
Never key the transceiver without an antenna connected, as this may cause damage to the transceiver. Do not operate the transceiver while charging its battery.
1.Install the belt clip on the transceiver, if desired.
2.Install the nylon carrying strap on the the trans-
ceiver, if desired.
3. Install the battery pack on the transceiver (see figure 6 and section 5.2).
4. Install the antenna onto the transceiver.
NOTE |
|
Water resistance of the transceiver is assured |
|
only when the battery pack and antenna are |
|
attached to the transceiver. | Figure 3 |
| Antenna Installation |
How to use the Quick Draw Belt Clip
1.Connect the hanger to the rear of the HX460S, using the supplied screw (Figure
Use only the screw included with the clip to mount the clip to the back of the transceiver!
2.Clip the Quick Draw Belt Clip to your belt (Figure 4-b).
3.To install the HX460S into the Quick Draw Belt Clip, align the hanger with the Quick Draw Belt Clip and slide the HX460S into its slot until a click is heard.
4.To remove the HX460S from the Quick Draw Belt Clip, Rotate the HX460S 180 degrees, then slide the transceiver out from the Quick Draw Belt Clip (Figure
(a)
belt
(b)(c) Figure 4
HX460S | Page 9 |
