![](/images/new-backgrounds/1199091/19909135x1.webp)
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication Setup menu must be changed to RADAR as shown below for communications.
1.From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2.Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT].
3.Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4.Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5.Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6.Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.4CPV550 Connections
1 RAM 2
I/O | AUX | GPS | VIDEO 1 | VIDEO 2 |
ACC 2
Cable
PLOTTER CABLE
WIRE COLOR | FUNCTION |
GREEN | GND |
No connection | AUX OUT+ |
BROWN (Port 1) | OUTPUT+ (TX+) |
BLUE (Port 1) | INPUT+ (RX+) |
BLACK | |
RED | POWER+ |
A switch MUST be connected to turn the Radar On or Off
Radar
Switch
|
| RADAR CABLE |
| WIRE COL. | FUNCTION |
| BLACK | DATA GROUND |
| ||
| ORANGE | DATA OUT+ |
| ||
| YELLOW | DATA OUT- |
| ||
| BROWN | DATA IN+ |
| ||
| RED | DATA IN- |
| ||
| GREEN | POWER ON/OFF SWITCH |
| BLUE | POWER ON/OFF SWITCH |
| BLACK | RADAR BATTERY GROUND |
| ||
| WHITE | RADAR BATTERY POSITIVE |
|
Battery Switch
Breaker panel
Battery
Figure 2.7.4 - CPV550 Connections
Page 20 |
| Radar Installation Manual |
|