Assembly Instructions | 30SS, 36SS, 45SS |
Step 8: Drift Cutters (if desired)
1.The drift cutters are attached to the main housing in the stored position.
2.Remove the two bolts on each drift cutter.
3.Reattach the drift cutters in the operating position.
4.Replace bolts and secure tightly.
Step 9: Skid Shoes
1.Skid shoes are stored in the hardware bag for shipping.
2.Remove from hardware bag, and install skid shoes using the provided fasteners
3.Insert the fasteners so the flat head of the carriage bolt is on the outside of the main housing.
CAUTION: Check the skids to ensure that the auger does not contact the paved or gravel surface. Adjust skids as necessary to make up for wear on the snow blower.
1.Check the tire pressure to ensure the tires are properly inflated.
2.Move skid shoes up and down to the desired position based on the surface texture.
If the surface is rougher adjust the skid shoes lower.
If the surfaces is smoother adjust the skid shoes higher. Firmly tighten the nuts that secure both skids to the auger sides.
Step 10: Headlight
1.Attach the upper set of handlebars with the control panel mounted.
2.Connect the headlight cable to the plastic connecter that is coming from the snow blower.
3.Insert headlight by clipping top tabs under the control panel and squeezing base to snap housing into place.
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE. Do not add fuel while the engine is running or is hot. Keep open flames, sparks, and heat away from the fuel and store fuel in containers specifically designed for that purpose. ADD FUEL
OUTDOORS ONLY. IF THE FUEL IS SPILLED, DO NOT START THE ENGINE. Manually push the snow blower away from the spill and wipe up immediately.
Step 11: Filling Oil and Gasoline
1.Fill the engine with SAE
2.Check that the fuel filter is clean and fill the tank with unleaded gasoline.
Rev: 12/21/2011 | Need Help With Assembly? | |
13 |
