|
|
| Troubleshooting | 30SS, 36SS, 45SS |
| |
|
|
| ||||
Problem | Possible Causes | Solution | ||||
|
|
|
|
| ||
Engine will not start | 1. | Key in the OFF position | 1. | Turn key to ON position | ||
|
| 2. | Insufficient fuel in the tank | 2. | Add gasoline | |
|
| 3. | Air bubble in the fuel line | 3. | Prime engine or shake bubble out | |
|
| 4. | Fuel valve in OFF position | 4. | Turn valve ON | |
|
| 5. | Choke not ON | 5. | Turn choke ON | |
|
| 6. | Choke linkage out of adjustment | 6. | Refer to Engine Owner’s Manual | |
|
| 7. | Loose spark plug wire | 7. | Add engine oil | |
|
| 8. | Fouled spark plug | 8. | Tighten wire or connections | |
|
| 9. | Plugged or dirty air filter | 9. | Clean or replace the plug | |
|
| 10. | Bad gasoline | 10. | Clean or replace the air filter | |
|
|
|
| 11. | Drain and replace with fresh gasoline | |
|
|
|
|
| ||
Fuel is leaking from the | 1. | Primer button was pressed too many | 1. | Do not press primer more than 3 times. Wipe off | ||
engine. |
| times. |
| excess fuel and allow to dry COMPLETELY before | ||
|
|
|
|
| attempting to start | |
|
| 2. | Fuel hose has become | 2. | ||
|
| 3. | Carburetor has contaminants in it | 3. | Fuel tank and carburetor needs to be flushed and | |
|
|
| causing the bowl to flood. |
| carburetor needs cleaning. | |
|
|
|
|
| ||
Engine will not start with | 1. | Not using proper gauge cord | 1. | Use 120V 16 gauge cord in good condition. | ||
electric starter | 2. | Safety key is loose | 2. | Verify the safety key is fully inserted. | ||
|
|
|
|
| ||
Engine will not keep | 1. | Water in the fuel | 1. | Drain and replace with fresh fuel | ||
running/quits | 2. | Fuel valve is OFF | 2. | Turn fuel valve ON | ||
|
| 3. | Low engine oil | 3. | Add engine oil | |
|
|
|
|
| ||
Augers do not turn | 1. | Shear pins holding the augers may | 2. | If the pins sheared, replace them as needed after | ||
|
|
| have sheared. |
| applying lubricant into the shaft. Call GXi Parts & | |
|
|
|
|
| Service at | |
|
|
|
|
| customerservice@gxioutdoorpower.com for parts. | |
|
|
|
| |||
Shaft is not turning | 1. | If the pins sheared, replace them as needed after | ||||
|
|
| have sheared. | applying lubricant into the shaft. | ||
|
| 2. | Check the gearbox. | Call GXi Parts & Service at | ||
|
|
|
| customerservice@gxioutdoorpower.com for parts. | ||
|
|
|
|
| ||
Snow blower always pulls | 1. | Skid shoes and / or scrapper blade | 1. | Adjust skid shoes and / or scrapper blade so the | ||
to one side |
| dragging more on one side than the |
| scrapper blade drags uniformly on the surface | ||
|
|
| other |
| being blown. | |
|
|
|
|
|
|
|
Rev: 12/21/2011
24