Stanley Black & Decker 45SS, 36SS, 30SS Assembly Instructions, Control Panel Handles, Chute Crank

Assembly Instructions 30SS, 36SS, 45SS

Step 1: Control Panel Handles

1. Align the two holes on each side of the control panel handles over the lower handle frame.

2. Insert the bolts through the handlebar holes and frame holes. Secure in place with hardware provided. Insert bolts from the inside.

Step 2: Directional Discharge Chute

1.Fit round spacer onto impeller housing before installing chute. Apply light coat of grease onto spacer.

2.Install the bolts for the retainer brackets bottom-up as shown. Insert the plastic spacer between the two metal parts.

DO NOT OVERTIGHTEN. If the bracket is too tight the chute will not move properly. Ensure there is enough space between the impeller housing and the bracket on all sides so that the chute rotates smoothly.

Bolt installed bottom-up

Step 3: Chute Crank

Attach the cable coming from the middle of the control panel by screwing the cable end onto the crank section.

Rev: 12/21/2011	Need Help With Assembly?
	1-919-550-3221 ext. 158
9