Safety Information and Warnings | 30SS, 36SS, 45SS |
Safety Information
Emission Control System Information
The U.S. and California Clean Air Acts EPA and California regulations require all manufacturers to furnish written instructions describing the operation and maintenance of emission control systems. The following instructions and procedures must be followed in order to keep the emissions from your engine within the emission standards. Maintenance, replacement, or repair of the emission control devices and systems may be performed by any engine repair establishment or individual, using parts that are ‘‘certified’’ to EPA standards.
Safety Label Locations
Safety labels are located on your snow blower to warn you of potential hazards. Read them carefully. If a label comes off or becomes hard to read, contact GXi Parts and Service, LLC for a replacement.
Operator Responsibility
It is the owner’s responsibility that all operators and mechanics must be trained and read this manual before operating the snow blower as well as being physically able individuals. They should be instructed about safe operating and mechanical procedures. If they can not read or understand English, it is the owner’s responsibility to explain all safety operating instructions. The owner or operator is responsible for accidents or injuries occurring to themselves, other people or property. Potential misfortunate incidents can be prevented by the owner/user.
Training
1.Read, understand, and follow all instructions on the machine and manual(s) before attempting to assemble and operate.
2.Operator must be familiar with all controls, their operations, and how to stop the engine and disengage the controls quickly.
3.Never allow children to operate this machine.
4.Never allow adults to operate this machine without proper instruction.
5.Exercise caution to avoid slipping or falling, especially when operating the machine in reverse.
6.Keep area of operation clear at all times.
WARNING! Do not use your STANLEY snow blower to carry passengers. Keep bystanders, helpers, pets and children at a safe distance from the machine while it is in operation. Inspect the area where the equipment is to be used and remove all objects such as rocks, toys, and wires which can be thrown by the machine causing serious injury or death.
Snow Blower Inspection
For your safety, inspect the snow blower before each use. Before you begin your inspection, be sure the following conditions are met: the snow blower should be on a level surface, with the ignition switch off, the key removed, and the augers disengaged. Also, disconnect the spark plug wires from the spark plugs and ground them against the engine to prevent inadvertent starting.
Wear appropriate clothing including hard hat, safety glasses and hearing protection. Long hair, loose clothing or jewelry may get tangled in moving parts.
Rev: 12/21/2011
1
