Service Adjustments | 30SS, 36SS, 45SS |
Adjusting Discharge Deflector
The discharge chute is preset at the factory, but may require adjustment over time or during maintenance. For adjustments, follow the procedure below:
1.Loosen the two nuts at the chute cable mount on the discharge chute.
2.To make the chute open more, adjust nuts so the cable end moves closer to the discharge deflector (upward).
3.To make the chute close more, adjust nuts so the cable end moves further from the discharge deflector (downward).
Changing Friction Wheel
If the friction wheel needs to be replaced for any reason:
1.Remove the six bolts to remove the cover underneath the control panel between the wheels.
2.Remove the bolt and nut in the hexagonal shaft carrying the friction wheel
3.With the bolt and locking nut removed, the shaft can be removed with the rubber friction wheel assembly.
4.Replace the friction wheel and reassemble in reverse order.
5.Resetting the neutral position may be necessary.
Replacement friction wheel rubber is available for purchase through GXi Parts & Service
Part# B05311
www.serviceandwarrantyonline.com
Replacing Headlight Bulb
1.Push the headlight case up from the bottom, then gently lift the headlight out.
2.Twist the black round wire harness counter- clockwise until the bulb is unlocked at the spot.
3.Replace the bulb and lock the headlight back into place the same way it was taken out.
Replacement bulbs are available for purchase through
GXI Parts & Service.
Part# B03211
Rev: 12/21/2011
22
