Stanley Black & Decker 45SS, 36SS, 30SS owner manual Check & Replacing the Transmission Drive Belt

Service Adjustments 30SS, 36SS, 45SS

Check & Replacing the Transmission Drive Belt

If belt needs to be changed or altered for any reason, the belt is located in the front of the snow blower behind the discharge chute and in front of the wheels.

1.Remove the cover that is protecting the snow blower’s belts. Remove the screws and simply lift

up the cover.

2.Remove the black belt and replace with a new belt.

3.Attach the cover and all parts as they were when taken off.

Check & Replacing the Augers/Impeller Belt There are two located in the front of the snow blower behind the discharge chute and in front of the wheels.

1.Remove the cover that is protecting the unit’s belts. Remove the screws and simply lift up the cover.

2.Remove the two belts and replace with new belt or belts depending on the belt’s condition.

3.Attach the cover and all parts as they were when taken off.

NOTE: Always change both belts at the same time.

Changing only one belt can lead to performance issues.

Also check for correct belt tension after changing belts.

Readjust if necessary.

Belt Spec: MXV4-370

Part# B08911

IMPORTANT! The snow blower belts are adjusted to ensure the augers stop turning within 5 seconds of releasing the augers/impeller control lever. If you are making any belt adjustments whatsoever, for your safety and the safety of others around you, you must ensure the belts are re-adjusted to achieve this design specification.

Rev: 12/21/2011

21