10 Printer Setup
❏Grasping the two back corners of the printer with the palms of your hands,
press back on the two raised areas on the top of the rear cover until it opens.
❏Swing the rear cover back and down until it stops.
Note:
You can also completely remove the rear cover by simply pulling it away from
the back of the printer after you open it.
❏Pass the fanfold paper through the space between the printer case and the
rear cover.
❏Unlock the two tractor covers by pushing their gray levers down, and slide
them so they are aligned approximately with the holes on the sides of the
paper. Also move the center paper support so that it is approximately
halfway between the two tractors.
❏Open the covers of both tractors and insert the paper so the tractor pins fit
into the holes of the paper.
❏Close the tractor covers and make final adjustments to the paper position by
moving the tractors. The paper should lie flat with no buckling or bulging
(tractors too close) or no stretching or elongation of the holes (tractors too