Error Code | Problem | Steps to take | |
|
|
| |
xxxx: [yyyy]: “zzzz”: entry | Entry zzzz in sec- | • Check the entry in the | |
is invalid | tion yyyy of file | configuration for zzzz. | |
• If you cannot find zzzz in the | |||
| xxxx contains an | ||
| invalid value. | Ethernet Adapter Manager | |
| program, you may have to use | ||
|
| ||
|
| the serial port or telnet | |
|
| configuration menus. See | |
|
| Appendix A for details. | |
|
|
| |
Unable to bring up interface | Configuration | Check the configuration for the | |
“lanX”. | values for the radio | PCMCIA radio card used. | |
| |||
| may be incorrect. |
|
Xxxx: <[yyyy]zzzz>: | Route values are out |
Unable to add route. | of range compared to |
| the interface values. |
•Set the route value to “automatic.”
•If “automatic” does not work for your Ethernet Adapter, check the values you set for the route to make sure they correspond to your other IP parameters.
UART Error – No Rx Buffer | Data is being sent to |
Available | the UART at a rate |
| faster than it can |
| clear its receive buff- |
| ers, and data is being |
| lost. |
•Enable flow control for your serial application.
•Note: If you are using the serial port menu system for configuration, flow control will not be enabled in the Ethernet Adapter. To avoid getting this while in the serial port configuration system, type slower.
Any other errors | • | If the event log instructs you |
|
| to contact Technical Support, |
|
| please do so now before |
|
| continuing. |
| • | Reset the Ethernet Adapter. |
|
|
|
