6. AUTO CUTTER (Auto-cutting models only)
6-1. Cutting Method
Cuts recording paper into continuous forms connected at only one point remain- ing uncut between adjacent forms.
Only one sheet of paper can be cut each time.
6-2. Cutting position
The paper is cut approximately 21.7 mm above the printing head.
Center of printer
Partial cutting with one uncut point left
Cutting position
Approx. 21.7mm
Printing head
position
Fig. | Fig. |
6-3. Auto cutting control codes
<ESC> “d” “0” or <ESC> “d” <0> <ESC> “d” “1” or <ESC> “d” <1> Refer to the control codes of chapter 10.
6-4. Other position to be observed
1When continuously cutting for more than 12 minutes, make a maximum of 10 cuttings per minute.
2When using for a long time, paper dust will gather around the cutter. Therefore, make sure to clean periodically. If paper dust is not removed, normal paper feeding may become impossible.
– 28 –
