– 129 –
APPENDIX
A-2. Auto Cutter Specifications
(1)Cutting frequency Max. 20 cuts per minute
(2)Thickness of paper 0.065 ~ 0.150 mm
A-3. Interface
RS232C serial interface/Two-way parallel interface (IEEE1284)/USB interface/
Ethernet interface/Wireless LAN Interface
A-4. Electrical Characteristics
(1)Input Voltage DC 24V±10%
(2)Current Consumption Operating: Approx. 2.0 A (at ASCII printing)
Peak: Approx. 10 A
Stand-by: Approx. 0.1 A
(3)Power Connector
Pin No.
Function
1 Drive power
2 Signal GND
3 N.C.
Shell Frame ground
13
2
<Viewed from Connector Surface>
Note:
•When using a printer power supply other than the optional AC adaptor
(PS60), be sure that the following cautions are observed.
•Use a power supply of DC 24 V ±10% and more than 2.0 A (5.0 A Load
10 sec. Min) with SELV output approved by IEC60950.
•Be careful about installing the printer in an area where there is noise. Take
the appropriate measures to protect against electrostatic AC line noise, etc.
A-5. Option
(1) USB Interface Board Unit (IFBD-HU04)
(2) Parallel Interface Board Unit (IFBD-HC04)
(3) 25 Pin RS-232C Interface Board Unit (IFBD-HD04)
(4) 9 Pin RS-232C Interface Board Unit (IFBD-HN04)
(5) Ethernet Interface Board Unit (IFBD-HE04)
(6) Wireless LAN interface Board Unit (IFBD-HW04)