– 24 –
ENGLISH
6-5. Upper Guide Adjustment
When the printer is shipped from the factory, the upper guides are adjusted for roll
paper with a 79.5–82.5 mm width. When using roll paper with a different width,
perform the following procedure to adjust the upper guides.
(1)Loosen the two screws for the left and right upper guides.
(2)Adjust the left and right upper guides according to the width of the roll paper,
making sure that each guide is approximately 2 mm to the inside of the edge
of the paper.
The scales on the metal plate on the cover are divided into 1 mm segments. The
two marks below the scales are used for 57.5 mm wide paper and the two
marks are used for 79.5 mm wide paper (also used for 82.5 mm wide paper).
If necessary, the screws for the left and right upper guides can be removed and
installed in the adjacent screw holes. If the roll paper width is 50 mm or less,
remove the center upper guide by removing its screw, and then adjust the left
and right upper guides.
Note:
When adjusting the upper guides, be careful not to pinch or apply unnecessary
force to the wires.
(3)Tighten the two screws.
2mm 2mm
Screws