Federal Communications Commission
Radio Frequency Interference
Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
For compliance with the Federal Noise Interference Standard, this equipment requires a
shielded cable.
This statement will be applied only for the printers marketed in U.S.A.
Statement of
The Canadian Department of Communications
Radio Interference Regulations
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian Department
of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.
The above statement applies only to printers marketed in Canada.
CE
Manufacturer’s Declaration of Conformity
EC Council Directive 89/336/EEC of 3 May 1989
This product, has been designed and manufactured in accordance with the International
Standards EN 61000-6-3 / 2001 and EN 55024 / 1998, following the provisions of the
Electro Magnetic Compatibility Directive of the European Communities as of May 1989.
EC Council Directive 73/23/EEC and 93/68/EEC of 22 July 1993
This product, has been designed and manufactured in accordance with the International
Standards EN 60950-1, following the provisions of the Low Voltage Directive of the
European Communities as of 2001.
The above statement applies only to printers marketed in EU.
Trademark acknowledgments
TSP1000: Star Micronics Co., Ltd.
ESC/POS: Seiko Epson Corporation
Notice
•All rights reserved. Reproduction of any part of this manual in any form whatsoever,
without STAR’s express permission is forbidden.
•The contents of this manual are subject to change without notice.
•All efforts have been made to ensure the accuracy of the contents of this manual at the
time of going to press. However, should any errors be detected, STAR would greatly
appreciate being informed of them.
•The above notwithstanding, STAR can assume no responsibility for any errors in this
manual.
© Copyright 2004 Star Micronics Co., LTD.
WEEE StatementIn the European Union, this label indicates that this product should not be
disposed of with household waste. It should be deposited at an appropriate
facility to enable recovery and recycling in accordance with legislation
under the WEEE Directive (Directive 2002/96/EC).
In der Europäischen Union dient dieses Symbol als Hinweis dieses
Produkt nicht im normalen Hausmüll zu entsorgen. Die Entsorgung sollte
als getrennte Sammlung über geeignete Einrichtungen/Sammelstellen
zum Recycling nach WEEE-Vorschrift (EU-Richtlinie 2002/96/EC) erfolgen.
Dans l’union europeenne (U.E.), cette etiquette indique que ce produit ne
doit pas etre jete avec les dechets menagers. Il doit etre depose dans un
container approprie permettant la recuperation et le recyclage en accord
avec les directives WEEE de la legislation europeennes (Directive 2002/
96/EC).
Nell unione europea, la presente etichetta indica che il prodotto non deve
essere gettato nei rifiuti, bensi’ riciclato attarverso gli appositi contenitori
secondo la legislazione sotto la Direttiva WEEE (Direttiva 2002/96/EC).