– 25 –
ENGLISH
7. Adjusting the Near-end Sensor
Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
1Open the printer cover.
2Determine the correct position of the adjuster from the following three
positions according to the paper loading method and the inner core diameter
of the roll paper.
Position 1: Using drop-in paper loading
Position 2: Using roll paper holder 2 (ø50.8 mm inner core)
Position 3: Using roll paper holder 1 (ø25.4 mm inner core)
3Insert the tip of a ballpoint pen or similar object into the hole of the adjuster,
and then push and slide the adjuster to the desired position.
(Level 1) (Level 2) (Level 3)
Position 3
Position 2
Position 1
The amounts of remaining paper that can be detected are shown in the following
table.
(1)Position 1
When using roll paper with an inside core diameter (A): ø25.4 and outside core
diameter (B): ø40
Level 1 Level 2 Level 3 Level 1 Level 2 Level 3
ø44 ø48 ø52 3.5 7.5 12.5
1.5 4.5 7.5
Remaining paper length
(Approx. m)
Detected diameter (C)
(Approx. mm)
80
105
Paper thick-
ness (
µ
m)